Standard Operating Procedure
for Par Sensor Baseline Check
Purpose: To verify
normal operation (incl. data file transfer) and integrity of monitoring
equipment, and to collect filter samples.
Required Tools:
Available at site: Air
duster, DI water, Kim wipes, Latex gloves, Q-tips
Flat-head screwdriver
Un-sampled Teflon
filters (37mm)
Teflon tweezers
Traveler sheet for
filter samples
Ziploc bags with
Petri slides (for sampled filters)
Log Displayed Values:
ARA
operates a web-based logging system designed for local operator’s communication
with central management called TrackOps,
which is password protected. The login
page is at www.atmospheric-research.com/trackops/login.aspx.
Actions related to the the meteorological sensors can
be logged under corresponding “tickets”.
All other meteorological sensors
i.
Check displayed
values for plausibility.
ii.
Check sound of
propeller anemometer (as OK for bearings).
iii.
Check fan pushing
air out from aspirated T/RH cross-arm.
iv.
Inspect cables
and sensors for signs of degradation (weather, animal droppings, etc). Make sure the PAR sensor is clean. If residue is visible on opaque diffuser
disk, wipe clean gently with DI water moistened Kimwipe.
v.
Check values
displayed in DAS window open on laptop screen.
vi.
Cover sensor with
original cap and confirm zero reading.
CONTACT INFORMATION
Main Contact
Dr.
Atmospheric Research &
Analysis, Inc.
(919) 599-5789
kbaumann@atmospheric-research.com
For DAS-Related Emergency Situations
Mr.
Atmospheric Research & Analysis, Inc.
730 Avenue F, Suite 220
Plano, TX 75074
(469) 583-4844
Filter Ship-To Address
Mr.
Atmospheric Research & Analysis, Inc.
1,000 Perimeter Park Drive, Suite G
Morrisville, NC 27560
(919) 995-0955
bedgerton@atmospheric-research.com
SRG Site Access
Mr. Larry Church
910-449-7733 Office
910-526-9565 Cell
Access key for entrance door
on catwalk below porch